Published xTool settings. Not tested by Kerfbook.

DIODE (BLUE) / 20W

xTool S1 20W
published settings.

3 published starting points for the xTool S1 20W, grouped by material category below. Keep the laser module and wattage matched to the source; another xTool module is not the same machine.

These are the maker's published starting points. We did not test them. Run a test card on your own sheet.

The S1 entries are maximum one-pass cutting figures from xTool's product page, not full power-and-speed recipes. The source does not state power, so power stays —.

PUBLISHED SOURCE
xTool S1 product page: maximum one-pass cutting speed and thickness ↗

Maximum one-pass figures published by xTool on its product page; power is not stated there.

Filter this machine

mm/min = mm/s × 60 · in/min = mm/s × 60 ÷ 25.4. Display rounded to 3 decimal places; source values stay unchanged.

Maker-published laser settings. A dash means the source did not publish a value.
Material / machineThicknessOperationPowerSpeed mm/sPassesLines/cmSource / raw
Wood
3mm BasswoodxTool S1 20WWood3 mmCut—7mm/s1—xTool source
Raw + notes

Category: Wood

Thickness: 3 mm

Lines/cm: —

Original: 3mm Basswood 20W 7mm/s

Extra: Maximum one-pass cutting speed published by xTool; power not stated

xTool S1 product page: maximum one-pass cutting speed and thickness

Maximum one-pass figures published by xTool on its product page; power is not stated there.

6mm BasswoodxTool S1 20WWood6 mmCut—4mm/s1—xTool source
Raw + notes

Category: Wood

Thickness: 6 mm

Lines/cm: —

Original: 6mm Basswood 20W 4mm/s

Extra: Maximum one-pass cutting speed published by xTool; power not stated

xTool S1 product page: maximum one-pass cutting speed and thickness

Maximum one-pass figures published by xTool on its product page; power is not stated there.

10mm BasswoodxTool S1 20WWood10 mmCut—3mm/s1—xTool source
Raw + notes

Category: Wood

Thickness: 10 mm

Lines/cm: —

Original: 10mm Basswood 20W 3mm/s

Extra: Maximum one-pass cutting speed published by xTool; power not stated

xTool S1 product page: maximum one-pass cutting speed and thickness

Maximum one-pass figures published by xTool on its product page; power is not stated there.

— = not published by the source. Open “Raw + notes” on a row to see its original text and any extra parameters. How we handle source data.